Stainless Steel Tire Changer Mounting / De-Mounting HEAD (Duck-head, Shoe). Fits older Coats, Corghi, and other (see below) brands of Tire Changers with round (not tapered) studs (the part on the bottom of the hexagon bar where the head mounts). Includes the 2 set screws for adjusting the angle. For models with a 27-28 mm (1-1/16" to 1-1/8") ROUND (but NOT TAPERED) stud. Not for models which have a tapered stud.

Mounting hole is approximately 1-1/8" in diameter.

• All-Tool (all models)
• Coats: RC-1, RC-5, RC-10, RC-15, RC-20, 9010, 9024, APX90. Also some early 5030 & 5060 models with round stud.
• Corghi (all models)
• Hofmann: 1610, 3200
• Hunter TCX series
• Ranger: some models, check measurements
• Sice: M39, S40, S41, S42, S45, S408MAXI, S435, S436, S436TOP
• MANY UNBRANDED AND PRIVATE BRANDED IMPORTS including Talyn and others

NOTE: to mount on some models, you have to remove the hexagon shaft and reinstall it 180 degrees rotated so the machined part of the stud is in the correct orientation for this head.

Interchanges: 322003, 258458, 900258458, 2202073, 2201432, 8183152, 183152, 8183429, 183429, TC-183429, TC183429, BW-1234-29